different way to set a fence post

Different ways of anchoring the fence posts

Generally, bury one quarter of the post to provide a firm foundation. If for example, your finished fence needs to be 6 feet (1.8 m) high, use 8 feet (2.4m) posts. One quarter of 8 feet is 2 feet. Therefore dig a 2 feet deep hole to take the 8 feet high post which will give 6 feet above the ground as the visible post.【Get Price】

How to Set Fence Posts That Won't Rot (DIY) | Family Handyman

Cedar has a reputation for durability, but unless a few guidelines are followed, cedar posts can fail in as few as five years. Three factors contribute to this early failure: poor drainage, low-quality wood and poor protection against insect damage. Here's how to install new cedar fence posts and avoid the problems that made your old posts rot.【Get Price】

How to Strengthen Fence Posts Without Pouring Concrete | Home.

Dig the post hole to at least 24 inches deep, using post hole diggers and a digging bar or a mechanical soil auger; for the best chance of preventing upheaval, set the post as deep as 40 inches if...【Get Price】

How to Install a Wood Fence Post (with Pictures) - wikiHow

The best way to install wooden fence posts depends on the type of soil you have—with dense, well-draining soil, you can usually just set the posts in soil or gravel, while sandy or muddy soil requires concrete for stability. Either way, we’ve got you covered! You’ll find step-by-step instructions for each method below. Method 1【Get Price】

Setting Fence Posts - Dos and Don'ts - Bob Vila

Setting a fence post doesn’t require uncommon skills or expensive tools, and doing it right doesn’t really take much longer than doing it the slapdash way. Whether your goal is privacy, a.【Get Price】

How to Set Posts in Concrete (without mixing) - YouTube

How to Set Posts in Concrete (without mixing): This video shows you step-by-step instructions for how to set a fence post in concrete, without mixing. The.【Get Price】

How to Set Fence Posts in a Straight Line | Hunker

Leave the string in position, and set each post so that its outside edge just touches the string when it's level. Alternatively, use a laser to double-check alignment when you're setting the posts. The laser should graze the outside edge of each post, meaning when the post is slightly tilted to the outside, it intercepts the beam.【Get Price】

Product Details